Our Work

JACKSONVILLE, FLORIDA

This project involved attaching site-cast Tilt-Up concrete panels to a structural steel frame. Tilt-Up was selected because of its ability to meet the tight schedule and cost constraints. Also, Tilt-Up offered the same architectural appeal as the precast design.

BOCA RATON, FLORIDA

This project involved design and construction of a four story parking garage constructed using tilt-up concrete bearing walls, precast concrete columns, precast-prestressed floor beams and cast in place supported concrete floor slabs.

MIAMI, FLORIDA

The building consists of load-bearing panels that support the precast concrete second floor and roof framing system. Precast double tees and beams are supported on continuous concrete haunches cast monolithically with the panels.

DAYTONA BEACH, FLORIDA

This project included the use of interior structural steel framing along with load bearing exterior masonry walls to support the second floor and roof framing systems. The exterior utilized a combination of brick and Alucobond cladding to match the architectural theme throughout the campus.

FLORIDA

The owner selected Tilt-Up because of its load-bearing capabilities, hurricane-resistance and architectural appeal.

MIAMI, FLORIDA

Interior load-bearing steel frame and exterior load-bearing Tilt-Up concrete panels.

ST. AUGUSTINE, FLORIDA

The walls were divided vertically into 25-foot-by-20-foot wide panels. In addition, interior floor slabs were constructed on site and then installed during construction